info@tecko.com.ua
WHERE CERTIFICATION IS REQUIRED
Conformity assessment or certification
Refusal letters
Module A according to technical regulations

Construction products, buildings and structures

The conformity assessment according to the requirements of the Technical Regulation of construction products, buildings and structures, approved by the Resolution of the Cabinet of Ministers of Ukraine No. 1764 dated December 20, 2006, is a mandatory requirement. National standards are used to confirm compliance, that provides a presumption of equipment compliance with the requirements of the Technical Regulation of construction products, buildings and structures.

It is necessary to submit an application to the Conformity Assessment Body "TECKO" for carrying out conformity assessment work with the requirements of the Technical Regulation. The technical file is attached in electronic form together with the application in accordance with the List defined by the relevant assessment procedures (modules).  It is necessary to send a completed application with a set of documents on e-mail: info@tecko.com.ua. Within 1-2 working days, we will definitely contact you to agree on the timing and cost of work.

The application for works
The list of required documents for the conformity assessment
The questionnaire for checking management systems (for module D)
Apply online

Information on the Technical Regulation of construction products, buildings and structures

The Technical Regulation of Ukraine Construction products, buildings and structures
The Resolution of CMU № 1764 dated 20.12.2006
Mandatory use beginning with 01.01.2020
Similar EU directive

Directive 89/106/EEC
In the EU, the Regulation (EU) № 305/2011 (CPD) is valid from 09.03.2011

The scope of this Technical Regulation applies to construction products, buildings and structures.
The main requirements for construction products, buildings and structures are:

  •  Mechanical resistance and stability. The construction works must be designed and built in such a way that the loadings that are liable to act on it during its constructions and use will not lead;
  • Safety in case of fire;
  • Hygiene, health and the environment;
  • Safety in use;
  • Protection against noise;
  • Energy economy and heat retention.

Modules of conformity assessment are applied: А, В, D, F, and their combination.

Affixing the mark of conformity to technical regulation is mandatory.

Two lists of national standards are approved by Order of Ministry of Regional Development №153 from 02.07.2020:

See the European Directive for information:
89/106/EEC Construction products (CPD) (від 21.12.1988). In the EU, the Regulation (EU) № 305/2011 (CPD) is valid from 09.03.2011.